Reviews Cts Pot 500k

KAISH 2x Plastic Black Thumb Rest Bass Thumbrest for Precision P Bass or J Bass Guitar

  • Strat Wiring Harness One Volume/Two Tones/5 way switch.
  • 2 x A500k,1 x B500k Pots with 18mm Shafts/Base Dia: 16mm .047 capacitors.
  • This harness is completely prewired. All you need to do is solder your pickups to the switch and ground them to the volume pot..
Check Stock

Prewired Wiring Harness Kit for LP Electric Guitar 2T2V 500K Pots 3-position Toggle Switch with Jack for Dual Humbucker Gibson Les Pual Style Guitar Electronics Replacements White Cap

  • Circuit wiring set for LP SG EPI Style electric guitar, Material: Metal and wire, Switch Cap: White.
  • 2 volume / 2 tones / 3 way switch, 2 capacitors, 1 input jack socket, prewired components make for an easy install, each tone pot has its own 2A473J capacitor, as well replace all the electronics..
  • 2 Volume and 2 Tone Knob Pots: 2 B500k full size potentiometer, 2 A500k full size potentiometer, Pots Shaft length: approx. 18mm / 0.71", Base diameter: approx. 16mm / 0.63", Switch: Approx. 18 x 28 x 49mm / 0.71 x 1.1 x 1.9 inch.
  • 2 tone potentiometers with the green capacitors and 2 volume potentiometer with no capacitor, pots are smooth and consistent, switch is excellent and cool that it came with a white tip.
  • Wiring diagram as the picture seventh shown, this harness is completely prewired. All you need to do is solder your pickups to the switch and ground them to the volume pots, more instructions please help to see the description as below. (Any other problem about product or replacement, please help to contact the seller, The way to Contact Seller: Find your order -- Contact Seller, thanks.).
Check Stock

EMG 1 or 2 Pickups HZ Passive Short Shaft Solderless Wiring Conversion Kit

  • 2 - 500k Volume Pots \ 2 - 500k Tone Pots.
Check Stock

LAMSAM Prewired Guitar Control Plate Assembly, Loaded 3-way Blade Switch Push Pull Potentiometer Excellent CTS Pot Speed Knobs for Telecaster Style Electric Guitars, Chrome

  • Designed for Tele style Guitars - prewired switch plate as necessary part for TL guitars, low noise, smooth feel, brass shaft, robust construction, improve tone.
  • High Volume - when put pickup switch on middle position and lift up the push pull pot, sound will become times louder than normal.
  • Top Quality Components - 3 position pickup switch with black tip.
  • 【3 Steps Install】1. remove mounting screws and then reinsert the new plate.
  • 2. desolder(or cut) your pickup leads from the old switch plate and solder them to the new one (can refer to the wiring diagram).
  • What You Get - 1 x TL style guitar control plate prewired.
Check Stock

CTS 500K Push Pull Short Shaft Audio Taper Potentiometers - Pair 2X - Includes Wiring Diagram

  • High Quality CTS Push Pull Pot - brass bushing and shaft.
  • Short Shaft (3/8" bushing height), 24-tooth fine spline shaft.
  • Double Pole Double Throw allows modification including coil splits, coil taps, phase shifting.
  • Not intended for use with import guitars using metric components.
Check Stock

HENGYEE Guitar Screw Kit Assortment with Custom Acrylic Storage Box for Electric Guitar Bridge,Pickup Ring, Pickguard, Tuner

  • Circuit wiring set for SSS SSH style Fender Squier Stratocaster electric guitar, material: metal and wire, switch cap: Black.
  • Wiring harness: 1 volume / 2 tones / 5 way switch, 2 capacitors, 1 output jack socket.
  • 1 Volume and 2 Tone Knob Pots: Two A500k potentiometer, 1 B500k potentiometer.
Check Stock

MAXCHEER set of 4 Guitar nuts, washers & lock washers for 1/4 2-Conductor Guitar/Bass Output Jack

  • Pack of 12 sets Steel Black Finish Pot and Jack Hardware.
  • 3/8th - 32 Nuts with Steel Black Finish Washers.
  • 3/8 - 32 thread for US Thread (CTS) Pots and Switchcraft Jacks.
  • 100% Quality Assurance :High quality is our only conviction. WE believe that you receive our products and will make you satisfied..
Check Stock

Shadow Kill Pot Guitar Bass Potentiometer with Push Switch to Kill the Sound Audio or Linear Taper A25K/A250K/A500K/B25K/B250K/B500K

  • Used for For electric guitar/bass,with push switch to kill the sound. Please consult your local luthier to install the professional pot..
  • Hard-wearing, specially designed potentiometer with momentary push-switch which can turn off the sound temporarily..
  • 250K for single coil pickups and 500K for humbucker pickups.
  • Audio Taper (A) increases or decreases in a sloped curve fashion.
  • Linear Taper (B) increases or decreases in a linear fashion. Audio Taper (A) are....
Check Stock

iSpring WCFM500K Iron, Manganese, and Hydrogen Sulfide Water Filtration System, Whole House or Well Water, Set & Forget, Last up to 10 Years

  • ...t filtration. Thanks to the automatic media regeneration feature, the system can last for up to 10 years without the hassle of filter replacements..
  • “Set & Forget'' Digital Control: With the LED screen, once you set your personalized auto-flush intervals depending on your incoming water quality and usage, WCFM500K is maintenance-free ever after, saving you time and money in the long run. It is indeed a silent guard at the point of entry for your entire house on well or city water..
  • Use No Chemicals: With new technology, WCFM500K whole house water filter uses only air for media regeneration. Unlike similar systems from other manufacturers, iSpring WCFM500K does not use any oxidizers or chemical feed other than the same air we breathe..
  • Peace of Mind Customer Service: Besides a 30-day money-back guarantee, iSpring stands behind its products by providing a 1-year manufacturer warranty and lifetime free technical support. Extended warranty plans are also available upon registration online. Local customers are welcome to visit us and pick up products at our warehouse in Cumming, GA..
  • Please Note: Unlike an RO system, this system will NOT reduce Total Dissolved Solids (TDS) and instead keeps healthy minerals in your water. If you are interested in a fil....
Check Stock

NEW EDGE EAS EGT STARTER KIT,DIESEL DRIVING,TOWING,COMPATIBLE WITH EDGE CS,CS2,CTS,CTS2 SYSTEMS

  • Brand New Edge EAS EGT Kit, Compatible with Edge CS/CS2 & CTS/CTS2 Systems (Holley Part #98620).
  • Features: Compatible With CS/CS2 & CTS/CTS2 Systems | Connect Multiple EGT Sensors to Monitor Temperatures in Different Locations | Ideal for Daily....
Check Stock