Reviews Module Display

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

Ximimark 1PCS 5V 12864 LCD Display Module 128x64 Dots Graphic Matrix LCD Blue Backlight

  • 12864 LCD Display Module 128x64 Dots Graphic Blue Color Backlight.
  • This product is a LCD display module with blue backlight, small and light appearance, suitbale for copiers, fax machines, laser printers, industrial test equipment, networking.
  • Package included： 1PCS x 5V LCD Display Module 128x64 Dots Graphic Matrix LCD 12864 Blue Backlight New.
  • If You Are Not Satisfied with Your Purchase for Any Reason, Please Feel Free To Contact Us at the Buyer Center or Support Email, 24/7 Quick Reply..
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

Basic 16x2 Character LCD - RGB Backlight 5V

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for Raspberry Pi 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

5 Pieces I2C Display Module 0.91 Inch I2C OLED Display Module Blue I2C OLED Screen Driver DC 3.3V~5V(Blue Display Color)

  • What will you get: there are 5 pieces OLED display module with blue display color, self-illuminated and no need backlight.
  • Power-saving display: the I2c oled display performs better than the traditional LCD display and with lower consumption sicne the IIC (I2C communications) simplifies connections.
  • Please note that these I2C OLED display module comes without pin headers.
  • More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
  • Good compatibility: this i2c oled display module is compatitable with Raspberry Pi 4B/3B+/3B/2B/Zero, compatitable with Arduino, also compatitable for ESP8266, ESP32, STM32, etc..
  • Product manual: as shown in the instructions.
Check Stock

4-Digit 7-Segment LED Display Clock Module with TM1637 IC Compatible with Raspberry Pi Arduino (Blue LEDs)

  • [Specifications] This is a basic 4-digit 7-segment Led display clock module, the LEDs are blue..
  • [Compatibility] This clock module uses TM1637 IC, it compatible with Raspberry Pi and Arduino.
  • [Easy to Use] The clock module connected to digital I/O via 2 pins..
  • [Easy to Install] This LED display designed with 4 mounting holes for easy installation..
  • [High Quality] The clock module is made of high quality electronic components, stable and reliable performance.
Check Stock

JM Set of 3 pcs Transparent 3D Floating Frame Display Holder/Box/Frames for Challenge Coins, AA Medallions, Antique, Jewelry,Gift, White, 2.75 x 2.75 x 0.75 Inches

  • What will you get: there are 5 pieces OLED display module with classic display color, self-illuminated and no need backlight.
  • Power-saving display: the I2C oled display performs better than the traditional LCD display and with lower consumption the IIC (I2C communications) simplifies connections.
  • Please note that these I2C OLED display module comes without pin headers.
  • More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
  • Good compatibility: this i2c oled display module is compatible with Raspberry Pi 4B/3B+/3B/2B/Zero, compatible with Arduino, also compatible with ESP8266, ESP32, STM32, etc..
  • Product manual: as shown in the instructions.
Check Stock

Key Display for AVR 8-Bit Digital LED Tube 8-Bit TM1638 Module

  • DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
  • 4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
  • CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
  • COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
  • WIDE APPLICATION: This module is suitable for 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..
Check Stock

LED LCD TV VByone LVDS Turn VGA Converter TV Motherboard Tester EXV2080 Good Price

  • ...ng the situation of misjudgment, making the test more perfect and judgment more accurate..
  • 2.When testing TV motherboard, it can test two groups of FHD LVDS signals at the same time, so the test is more comprehensive. At the same time, EXV2080 also has its own image-detail display function, which makes the characters clearer when adjusting the LCD module parameters. The built-in LCD can achieve local definition equivalent to 1600 * 960 in magnification mode. When the external display is connected, the dual screen display function can be achieved, and the local definition in the magnification mode is equivalent to that of 2K display..
  • 3.EXV2080 has its own operation interface, which can be directly seen all parameters of TV motherboard and LCD module. EXV2080 also has its internal protection circuit. When VLCD and GND are short circuited, it can automatically judge and prohibit output..
  • 4.EXV2080 withmicroUSBdataupgradeinterface,support software upgrade. When there isanew demand,you can upgrade thefirmware to maintainits best compatibility..
Check Stock

waveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard

  • Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
  • Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
  • 1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
  • 10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
  • Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.
Check Stock