Reviews High pass Filter

BOSS Audio Systems BX35 Electronic Car Crossover - 3 Way Pre-Amp Fine Tune Your High-Mid-Low Range Speaker Frequencies

  • Front / Rear / Sub Input, Front / Rear / Sub Outputs.
  • Front High Pass Filter 65 Hz to 4.5 kHz, Rear High Pass Filter 45 Hz to 1.6 kHz.
  • Variable Subwoofer Filter 40 Hz – 250 Hz, Variable High Pass Filter 45 Hz – 5 kHz.
  • Crossover Slope 12 dB / Octave, Variable Subwoofer Phase 0 – 180 Degrees.
  • Variable Bass Boost 0 – 18 dB, Variable Bass Boost Frequency 25 Hz – 250 Hz.
Check Stock

ART 351 EQ 31-Band 1/3 Octave Graphic Equalizer

  • The 351 is a single-channel, 31-band, 1/3-octave graphic equalizer with many features: constant Q circuitry with a 3% center frequency accuracy, 20mm center detent sliders, selectable boost/cut range of 6dB or 12dB, active balanced and unbalanced input and output connections, adjustable high-pass filter, adjustable low-pass filter, variable input level control, clip level indicators, ground lift switch, internal power supply, and selectable line voltage switch.
  • The ART 351 Single Channel 31-Band Equalizer features a rugged all-steel chassis that occupies a single 19" rackspace.
Check Stock

Presonus Temblor T10 Powered Studio Subwoofer, Multicolor

  • 10-Inch glass-composite low-frequency transducer.
  • power: 100-120V 50/60 Hz or 220-240V 50/60 Hz.
  • Input gain control (-30 dB to +6 dB, continuously variable) and continuously variable low Pass filter (50 Hz to 140 Hz).
  • Switchable high pass filter removes frequency content below 80 Hz from the full-range signal sent to the main monitors.
  • Momentary footswitch (included) Bypasses the subwoofer, high pass filter, and sub out.
  • Left and right, balanced XLR and ¼” TRS and unbalanced RCA main inputs.
Check Stock

Rockville KRYPTON F2 2400w Peak/600w RMS 4 Channel Amplifier Car Stereo Amp

  • Rockville KRYPTON F2 2400w Peak/600w Dyno-Certified RMS 4 Channel Amplifier Car Stereo Amp..
  • Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 150 Watts x 4 Channels.
  • 4 Ohm Bridged: 300 Watts x 2 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 600 Watts x 4 Channels. 4 Ohm: 400 Watts x 4 Channels. 4 Ohm Bridged: 1200 Watts x 2 Channels..
  • All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Digital Voltage Display on Amp..
  • Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Adjustable Subsonic Filter: 15Hz -40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz – 4KHz. Adjustable Band Pass Filter: 15 Hz - 4 kHz (use both the HPF and LPF filter). Adjustable High Pass (Subsonic) Filter: 15 Hz - 4 kHz.
Check Stock

California Project

  • Built-in Amplifier - With a MOSFET power supply you get improved switching speeds, better performance with less power from the driver, lower gate-to-drain feedback capacitance, lower thermal impedance for higher switching frequencies.
  • Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes above the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
  • High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the LOPRO10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs.
  • Low-Level Inputs - Line level inputs (RCA inputs / low-level inputs) use RCA interconnect cables to link the LOPRO10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers.
  • Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  • Specs – 15.5” x 11” x 3”. If you are short on space, this is a great solution for you. The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. Weight: 13 lbs..
Check Stock

Rockville Krypton F1 1600w Peak / 400w RMS 4 Channel Amplifier Car Audio Amp

  • Rockville KRYPTON F1 1600w Peak / 400w Dyno-Certified RMS 4 Channel Amplifier Car Audio Amp..
  • Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 100 Watts x 4 Channels 003c1% THD+N. 4 Ohm: 70 Watts x 4 Channels 003c1% THD+N..
  • 4 Ohm Bridged: 200 Watts x 2 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 400 Watts x 4 Channels. 4 Ohm: 280 Watts x 4 Channels. 4 Ohm Bridged: 800 Watts x 2 Channels..
  • All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Digital Voltage Display on Amp. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry..
  • Adjustable Subsonic Filter: 15Hz -40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz – 4KHz. Adjustable Band Pass Filter: 15 Hz - 4 kHz (use both the HPF and LPF filter). Adjustable High Pass (Subsonic) Filter: 15 Hz - 4 kHz. 2CH/4CH Input Mode Switch. 8 Volt Preamp Circuitry.
Check Stock

Anti-Interference High Reliability 433MHz New Denoise Bandpass Filter BPF SMA Interface for Block Frequencies

  • Power supply EMI filter is a kind of reactance-type low-pass filter, installed at the power supply input of electronic equipment..
  • It can inhibit noise transmitted through grid power cable, and can inhibit high-frequency interference signals generated by the electronic device itself..
  • High quality imported components provide obvious filtering effect..
  • EMI has become a must have device installed in electronic equipment..
Check Stock

YWBL-WH Bandpass SMA Filter BPF Anti-interference 2.45G 433M 1575M 900M 1090M New Denoise SMA Interface

  • 【Easy to Debug】A bandpass filter is a device that allows a specific frequency band to block other frequencies at the same time. It is easy to debug, it has good selectivity and stability.
  • 【Professional Design】The filter has the characteristics of low insertion loss, high stopband rejection and high image attenuation, high power tolerance, low cost and miniaturization.
  • 【High Quality】The band-pass filter is made of high‑quality materials, which has high precision, stable performance, high sensitivity, durable in use.
  • 【Features】The 433mhz band pass filter is processed by professional manufacturing, it has precise design, high reliability, stable and reliable working performance.
  • 【After Sales】If you have any questions about your order, please feel free to contact us directly and we will get back to you within 24 hours.
Check Stock

3000W Class D Smart Amplifier 1-2 Ohm Monoblock Pro Car Audio Taramps SMART3

  • Class D MOSFET Mono Block Power Amplifier.
  • RMS Power at 1 Ohm:1500 Watts，RMS Power at 2 Ohms: 800 Watts，RMS Power at 4 Ohms: 510 Watts.
  • Low Pass Crossover - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s).
  • Remote Subwoofer Level Control Included.Variable Bass Boost - Variable Bass Boost 0 to 12dB(50Hz) allows you to adjust the low bass within the boost range to just the way you like it..
  • Warranty -TopstrongGear provides a powerful 2 year Platinum Online Dealer Warranty.
Check Stock

Febreze FHT170W HEPA-Type Tabletop Air Purifier with Febreze FRF101B Replacement Dual Action Filter

  • Dual-action HEPA-type filter captures up to 99% of airborne pollutants & allergens such as dust, smoke, pollen and pet hair & dander that passes through the filter.
  • ODOR REDUCING HEPA FILTER: This HEPA-Type filter with built-in odor reducing pre-filter captures up to 99% of microscopic particles 2 microns & larger from the air that passes through the filter..
  • CLEANER, FRESHER AIR: The carbon infused OdorGrab filter targets tobacco smoke, kitchen odors, pet odors, pet dander, & any other common household odors from the air that passes through the filter..
Check Stock