Reviews V Channel

Analog Discovery Systems Kit: USB Oscilloscope & Logic Analyzer

  • Two-channel USB digital oscilloscope, spectrum analyzer, and network analyzer (±25V, differential, 14-bit, 100MS/s, 30MHz+ bandwidth).
  • Two-channel arbitrary function generator (±5V, 14-bit, 100MS/s, 12MHz+ bandwidth).
  • 16-channel digital logic analyzer, pattern generator, and protocol analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s).
  • Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS).
  • Additional instruments including a data logger, impedance analyzer, and power supplies.
Check Stock

ALPINE S-A32F 320w RMS 4-Channel S-Series Car Audio Amplifier Class D+Amp Kit

  • (1) Alpine S-A32F 320 Watt RMS 4-Channel S-Series Car Audio Amplifier Class D Amp. (1)RockvilIe RWK42 4 Gauge 4 Chan Car Amp Wiring Installation Wire Kit (2) RCA's. Install. Terminal Layout: One side. Small footprint for easy installation. Screw terminals (for speaker and power cables). General. Amplifier Type: Class-D (Digital). Channel Design: 4/3/2 Channel. Thermal Management Control. Top Mounted LED Power/Status Indicator. Speaker Level Input with remote turn on.
  • Crossover: Adjustable Low-pass (LPF) / High-pass Filter (HPF). Gain Control: Adjustable. Bass Control: Remote Bass Control (RUX-KNOB2) Ready. Max Power Output Ratings. Total Max Power: 640W. RMS Power Ratings. Per Channel into 2 Ohms, 14.4V (%THD+N): 4 x 80W. Per Channel into 4 Ohms, 14.4V (%THD+N): 4 x 55W. Bridged into 4 Ohms, 14.4V (%THD+N): 2 x 160W. Sound Tuning. Crossover: Variable LPF, 50-400Hz (-12dB/oct ). Crossover: Variable HPF, 50-400Hz (-12dB/oct ). General.
  • Power Requirements: 14.4 V.DC (9 - 16 V allowable). Input Sensitivity (RCA Input): Hi: 0.5 - 10 V Lo: 0.2 - 4.0 V. High Level Input with automatic power on. Cable size: Power Cable AWG 8, SPK Cable AWG 10. Frequency Response (+0, -....
Check Stock

Orion HCCA1000.4 4 Channel Amplifier 1000 Watts Car Audio Car Stereo Amp

  • RMS Watts @ 4 Ohm Stereo 14.4V:   150 Watts X 4 Channel / RMS Watts @ 2 Ohm Stereo 14.4V: 250 Watts X 4 Channel / RMS Watts @ 4 Ohm Bridge 14.4V: 500 Watts X 2 Channel.
  • Hi Pass Freq.   50Hz-2KHz / Low Pass Freq. 50Hz-2KHz.
Check Stock

HiLetgo USB Logic Analyzer Device With EMI Ferrite Ring USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug

  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • Input Impedance: 1Mohm || 10pF (typical, approximate).
Check Stock

NOYITO USB Logic Analyzer Device with USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug

  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • Input High Voltage: 2.0V to 5.25V003cbr003e.
  • Input Impedance: 1Mohm || 10pF (typical, approximate).
Check Stock

MUSYSIC MU-D16K Professional 2-Channel 2x8000 Watts D-Class 1.5U Power Amplifier

  • 2-Channel Professional D-Class Power Amplifier 2x8000 Watts Peak Output.
  • Stereo Output Power: "2x8000W PEAK, 2x4000W Program, 2x2000W RMS @ 2Ω" "2x4000W PEAK, 2x2000W Program, 2x1000W RMS @ 4Ω" "2x2000W PEAK, 2x1000W Program, 2x500W RMS @ 8Ω" / Bridge Output Power: "8000W PEAK, 4000W Program, 2000W RMS @ 4Ω" "4000W PEAK, 2000W Program, 1000W RMS @ 8Ω".
  • Frequency Response: 20Hz-20KHz,+0,-1dB at watts / THD+N(20Hz-20KHz) ＜0.23％20Hz-20KHz / Siew Rate ＞30V/us / Damping Factor ＞150 / Output Circuitry Class AB / Signai to Noise Ratio ≥96dB / Cross Talk ＞80dB / lnput Sensitivity(8Ω) 1V / input lmpedance 20 k Ω baiance / 10 k Ω unbalanced unbalance balancing 20 k / 20 k /.
  • Three cooling fans / Connectors Input: XLR input, 1/4" input: Speakon connector Output: Speakon, locking type socket, Power Requirements: 90v-250v 50Hz.
  • Controls Panel: the power switch, channel 1 and channel 2 channel gain control.
  • After the board: working mode, pressure limit./ lndicators Panel: the power switch, channel 1 and channel 2 channel gain control.
  • After the board: working mode, pressure limit./ Amplifier Protection With short circuit, overload, overheat, cut peak pressure limit, dc, soft start, relay zero current switch, super audio and radio frequency protecti....
Check Stock

74LS153 Dual 4-Input Multiplexer (2 Pack)

  • Wide Range of Digital and Analog Signal Levels Digital: 3 V to 20 V Analog: ≤ 20 VP-P, Break-Before-Make Switching Eliminates Channel Overlap.
  • Low ON Resistance, 125 Ω (Typical) Over 15 VP-P Signal Input Range for VDD – VEE = 18 V.
  • High OFF Resistance, Channel Leakage of ±100 pA (Typical) at VDD – VEE = 18 V, Maximum Input Current of 1 µA at 18 V Over Full Package Temperature Range, 100 nA at 18 V and 25°C.
  • Logic-Level Conversion for Digital Addressing Signals of 3 V to 20 V (VDD – VSS = 3 V to 20 V) to Switch Analog Signals to 20 VP-P (VDD – VEE = 20 V) Matched Switch Characteristics, rON = 5 Ω (Typical) for VDD – VEE = 15 V Very Low Quiescent Power Dissipation Under All Digital-Control Input and Supply Conditions, 0.2 µW (Typical) at VDD – VSS = VDD – VEE = 10 V.
  • Binary Address Decoding on Chip, 5 V, 10 V, and 15 V Parametric Ratings, 100% Tested for Quiescent Current at 20 V.
Check Stock

JBL Professional EON ONE Portable All-in-One Linear-Array 6-Channel PA System Black

  • Your purchase includes One JBL Professional EON ONE 6-Channel base | Height spacers (x2), Column speaker array (x1), Power cable & quick-start guide.
  • Speaker dimensions – 24.7” D x 20.2” W x 30.2” H | Weight – 40.8 lbs. | Voltage – 100V-120V / 220V-240V, selectable 50/60Hz | Max SPL –....
  • 6-channel input/output – combo ¼” / XLR (x2), balanced ¼” TRS or RCA jacks (x2), 3.5mm jack (x1), or wireless Bluetooth connection.
  • Unobstructed 10” bass-reflex subwoofer for accurate low-frequency response.
  • Proven JBL Professional sound quality and powerful 6-channel mixer with easy-to-use controls.
Check Stock

USB Logic Analyzer Device with EMI Ferrite Ring USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 SCM

  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions.
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • Input Impedance: 1Mohm || 10pF (typical, approximate).
Check Stock

MUSYSIC MU-D9600 Professional 4-Channels 2x9600 Watts D-Class 1U Power Amplifier

  • 4-Channels Professional D-Class Power Amplifier 2x9600 Watts Peak Output.
  • Stereo Output Power: "4x4800W PEAK, 4x2400W Program, 4x1200W RMS @ 2Ω" "4x2400W PEAK, 4x1200W Program, 4x600W RMS @ 4Ω" "4x1200W PEAK, 4x600W Program, 4x300W RMS @ 8Ω" / Bridge Output Power: "2x4800W PEAK, 2x2400W Program, 2x1200W RMS @ 4Ω" "2x2400W PEAK, 2x1200W Program, 2x600W RMS @ 8Ω".
  • Frequency Response: 20Hz-20KHz,+0,-1dB at watts / THD+N(20Hz-20KHz) ＜0.23％20Hz-20KHz / Siew Rate ＞30V/us / Damping Factor ＞150 / Output Circuitry Class AB / Signai to Noise Ratio ≥96dB / Cross Talk ＞80dB / lnput Sensitivity(8Ω) 1V / input lmpedance 20 k Ω baiance / 10 k Ω unbalanced unbalance balancing 20 k / 20 k /.
  • Three cooling fans / Connectors Input: XLR input, 1/4" input: Speakon connector Output: Speakon, locking type socket, Power Requirements: 115v-230v 50/60 hz.
  • Controls Panel: the power switch, channel 1 and channel 2 channel gain control.
  • After the board: working mode, pressure limit./ lndicators Panel: the power switch, channel 1 and channel 2 channel gain control.
  • After the board: working mode, pressure limit./ Amplifier Protection With short circuit, overload, overheat, cut peak pressure limit, dc, soft start, relay zero current switch, super audio and radio fre....
Check Stock