Reviews Usb Audio Interface Under 1000

JANST 3.5mm Male AUX Audio Plug Jack to USB 2.0 Female Converter Cable Cord 8 inch

  • Attention for Using: Make sure the audio system(3.5mm AUX interface of the GPS, CD, DVD audio) on your car is equipped with MP3 audio Decoding Playback Function.Only under this condition can the cable be used..
  • Function: Use for vehicle navigation and vehicular audio..
  • Installation: The 3.5mm plug should be connected to GPS,CD,DVD audio 3.5mm AUX audio interface of the car, The USB port should be connected to the U disk.Implement auto plays songs of USB flash disk..
  • Note: There is compatible problem with this cable,not all models can be used.Ordinary car is not equipped with MP3 audio decoding playback function.It is recommended to carefully check the car manual first.Please confirm your car has this feature before buying..
Check Stock

Magewell SDI USB Capture Plus - 32050

  • Capture: USB Capture SDI Plus by Magewell captures SD /HD /3G-A /3G-B/2K SDI signals from a wide range of devices including high definition cameras....
  • Input Resolution: The maximum input resolution and frame rate is 2048 x 1080. The USB Capture SDI Plus can deliver the captured video to a computer at....
  • Monitoring: The USB Capture SDI Plus has an SDI input interface as well as a an SDI loop through interface, which allows for monitoring the image....
  • Input and Output Functions: Additionally, the new USB Capture SDI Plus has new audio input and output functions.
  • 3.5mm Audio Interface: A 3.5mm audio interface allows for capture of analog audio from a separate audio device.
Check Stock

Acer USB Type-C Dock D501 Certified Works With Chromebook | 2x HDMI 2.0 | 2x DP | 1 x USB Type-C | 2 x USB 3.1 Gen2 | 4 x USB 3.1 Gen1 | Ethernet | Requires USB 3.1 Type A or USB Type-C on Computer

  • Video Interface (Supporting FHD): 2 x HDMI 2.0 and 2 x Display Port 1.4.
  • Ethernet:1 x RJ-45 connector (Connect to Ethernet 10/100/1000 Mbps).
  • USB Ports: 1 x USB-C 3.1 Gen2, 5V/3A, data only.
  • DFP | 2 x USB-A 3.1 Gen2, 5V/1.5A, support BC 1.2 | 4 x USB-A 3.1 Gen1, 5V/0.9A.
  • Power to Notebook: Up to 60W | Audio Jacks: 1 x 3.5mm Audio (Headphone/Speaker Jack) | Display Max Resolution: Up to [email protected].
Check Stock

Dell System Board (Motherboard) for OptiPlex 330 (Refurbished)

  • Genuine Dell Motherboard For Optiplex 330 MT or SD Systems.
  • Chipset: Intel G31 w/ ICH7R | Processor: Intel Pentium, Celeron, Core 2 Duo, Socket 775 |.
  • Memory: 2 DIMM slots supporting up to 4 GB of RAM, Capacilities: up to 2 GB | Video: Integrated Intel Graphics | Audio: Integrated Audio Sound Controller, ADI 1984 High Definition Audio.
  • Expansion Capabilities: 1 PCI-E X16 slot, supports x16, x8, x4, and x1 modes/cards, 2 PCI 32Bit / 33MHz slots |.
  • Peripheral Interfaces: (8) 2.0 USB (front and back) (1) parallel printer port (1) serial ports 1 VGA 4 - Serial ATA (SATA) Interface Ports 1- 10/100/1000 Ethernet Port | Motherboard Part Number: KP561, N820C, TW904.
Check Stock

Gigabyte GA-970A-DS3 AM3+ AMD 970 SATA 6Gb/s USB 3.0 ATX AMD Motherboard

  • ...HD audio codec. High Definition Audio. 2/4/5.1/7.1-channel. Support for S/PDIF Out. LAN: Realtek GbE LAN chip (10/100/1000 Mbit).
  • Expansion Slots: 1 x PCI Express x16 slot, running at x16. 1 x PCI Express x16 slot, running at x4. 3 x PCI Express x1 slots. 2 x PCI slots. Support for AMD CrossFireX technology..
  • Storage Interface: 6 x SATA 6Gb/s connectors supporting up to 6 SATA 6Gb/s devices. Support for RAID 0, RAID 1, RAID 5, RAID 10, and JBOD..
  • USB: South Bridge: Up to 12 USB 2.0/1.1 ports. Etron EJ168 chip: Up to 2 USB 3.0/2.0 ports on the back panel.
  • Internal I/O Connectors: 1 x 24-pin ATX main power connector/1 x 4-pin ATX 12V power connector/6 x SATA 6Gb/s connectors/1 x CPU fan header/2 x system fan headers/1 x power fan header/1 x front panel header/1 x front panel audio header/1 x S/PDIF Out header/3 x USB 2.0/1.1 headers/1 x Clear CMOS jumper.
  • Back Panel Connectors: 1 x PS/2 keyboard/mouse port. 6 x USB 2.0/1.1 ports. 2 x USB 3.0/2.0 ports. 1 x RJ-45 port. 3 x audio jacks.
Check Stock

GIGABYTE GA-M68MT-S2P AM3 NVIDIA GeForce 7025/nForce 630a chipset Micro ATX AMD Motherboard

  • CPU: Support for AMD AM3/Phenom II/Athlon II processor. Chipset: NVIDIA GeForce 7025/nForce 630a chipset.
  • Memory: 2 x 1.5V DDR3 DIMM sockets supporting up to 8GB of system memory, Dual channel memory architecture, Support for DDR3 1333(OC)/1066/800 MHz memory modules.
  • Audio: Realtek ALC889 codec, High Definition Audio, 2/4/5.1/7.1-channel. LAN: Onboard Realtek RTL8211CL (10/100/1000Mbit).
  • Expansion Slots: 1 x PCI Express x16 slot, running at x16. 2 x PCI Express x1 slots. 1 x PCI slot.
  • Storage Interface: 4x SATA 3Gb/s connectors. Support for RAID 0, RAID 1, RAID 5, RAID 10 and JBOD.
  • Internal I/O Connectors:1 x 24-pin ATX power connector/1 x 4-pin ATX 12V power connector/4 x SATA 3Gb/s connectors/1 x CPU fan header/1 x system fan header/1 x front panel header/1 x front panel audio header/3 x USB 2.0/1.1 headers/1 x parallel port connector/1 x clearing CMOS jumper.
  • Back Panel Connectors:1 x PS/2 keyboard port/1 x PS/2 mouse port/1 x serial port/1 x D-Sub port/4 x USB 2.0/1.1 ports/1 x RJ-45 port/3 x audio jacks (Line In / Line Out / MIC In).
Check Stock

AURSINC SHARI PiHat - Portable SA818 Ham Allstar Radio Interface Compatible with Raspberry Pi 2/3/4 | Raspberry Pi Hosted Allstar Node | UHF Frequency Range 1W 420-450MHz/70cm | Amateur Radio Operator

  • [What Is It] Small, portable with self contained radio and antenna, SHARI(SA818 Ham Allstar Radio Interface) is designed for construction and uses in the amateur radio service, works with a Pi2/Pi3 or Pi4, SHARI RF output power is 500 to 1000(default) milliwatts.
  • [Allstar Node] SHARI PiHatU implements a Raspberry Pi hosted Allstar node using a NiceRF SA818 embedded UHF (420-450 MHz|70cm) radio module.
  • In order to create an Allstar node, SHARI plugs into two USB jacks on a Raspberry Pi2/Pi3 or Pi4 for power, the Allstar interface and radio programming (a short M/F USB extender cable can be used if desired) ；Note: only work with allstar node or any analog node.
  • [Power Supply] SA818 Ham Allstar Radio Interface is a power supply intended for the version of the Raspberry Pi. These supplies typically provide 5.1 to 5.2 VDC to the Pi. Current requirements vary with version. Numerous problems with Allstar Nodes have been traced to inadequate power supplies..
  • [Feature 1] Front panel LEDs indicate the status of SHARI-POWER (green), USB Audio CONNECTION STATUS (blinking green), COS (green) and PTT (red).
  • SHARI PiHat uses 5 volts from the Pi, and the best place to measure it is from pin 8 (+5) to pin 9 (GND) of the SA818 module.
Check Stock

M-Audio Recording, Streaming and Podcasting Bundle – M-Track Duo USB Audio Interface, BX3 Stereo Speakers and Marantz MPM-1000 Condenser Microphone

  • Podcast, Record, Live Stream, This Bundle Covers it All – M-Track Duo USB Audio Interface for Mac or PC, BX3 120-Watt powered speakers and MPM1000 Desktop or Stand-mounted Condenser microphone.
  • Be Ready for Anything with this Versatile M Audio Interface - Record guitar, vocals or stereo line input signals with two combo XLR / Line / Instrument Inputs with phantom power.
  • Hear Every Detail - Stereo Speakers with an Acoustically-inert MDF cabinet and bass reflex design for deep, rich sound.
  • 3.5” Black Kevlar woofers and 1” natural silk dome tweeters.
  • A Mic for any Occasion - Cardioid mic capsule reduces ambient noise.
  • Wide frequency response (20–20,000Hz) delivers clear audio for recording instruments, YouTube videos, singing and voice-over work.
  • Whether you’re a Podcaster or Beat Maker, this software suite won’t disappoint - Includes: Pro Tools | First M-Audio Edition, MPC Beats, Xpand!2, Eleven Lite guitar amp plugin and 20 AVID plugin FX.
Check Stock

risingsaplings 10pcs USB Type B Female Breakout Board Connectors 4 pin 2.54mm Output

  • Excellent quality usb b socket , very suitable for replacing damaged or poor performance USB interface, after purchase can make your device look new..
  • Relatively easy to install, very suitable for maintenance of USB audio, MIDI keyboard and other equipment interface.Relatively easy to install, very suitable for maintenance of USB audio, MIDI keyboard and other equipment interface..
Check Stock

Professional Wireless DJ Audio Mixer - 4 Channel Bluetooth Controller Sound Mixer USB Audio Interface 2 Combo Jack XLR+6.35mm Mic/Line/Guitar in 3.5mm RCA AUX Headphone Jack - Pyle PAD43MXUBT

  • 4 CHANNEL: This wireless 4 channel audio interface controller DJ mixer machine by Pyle is the perfect way to mix audio from MP3, mic, and bluetooth....
  • BLUETOOTH MUSIC STREAMING: This sound mixer USB interface mixer is compatible w/ bluetooth and works w/ smartphone, tablet, laptop, pc w/ simple....
  • USB INTERFACE AND MIX MONITORING: This personal mixer has a USB port  to connect to a computer and use it as an audio output and input interface for....
  • 6 INPUTS: Pyle DJ mixer USB audio interface mixer is equipped w/ 2 combo jack XLR+6.35mm for mic/line/guitar inputs, 2-TK, Stereo RCA in, AUX, and....
  • +48V PHANTOM POWER: For the reliable power source, the stage/studio sound mixing console features a +48V phantom power supply. has ultra-low noise....
Check Stock