Reviews Sony Smart Band Swr 12

Antenna Analyzer Meter 1-60MHz Shortwave SWR Antenna Analyzer with 1.0 to 9.99 SWR Usable Measurement Range for Ham Radio

HIGH QUALITY-- This Antenna Analyzer adopts black case would protect the antenna analyzer from external damage, durable in use..
CONVENIENT OPERATION-- 5 operation buttons are easy and convenient to operate. You can selects operation mode, band and extended functions..
FEATURE-- The antenna tester is Powered by DC 12 to 14V 500mA external power with 2.1mm power jack(center pin positive), just connect the power and....
WIDE MEASUREMENT RANGE-- SWR usable measurement range of this analyzer is 1.0 to 9.99. step size: user configurable increments of 100Hz, 1KHz, 10KHz,....
APPLICATION-- Measure antenna electrical parameters: SWR, impedance (resistance + reactance), capacitance, inductance. It can measure feed-point....

The single-band 80m-10m end-feed half-wave linear antenna provides the antenna. It is designed as a highly portable wired antenna that can be easily set as an inverted V-shaped, horizontal, tilted, or vertical radiator (at higher frequencies)..
Your feeder is inherently balanced, so no separate feeder is required. The high-impedance half-wave line is matched to your 50-ohm feed point through an integrated impedance-matching toroidal transformer with a rated power of 10 watts..
Use a high-voltage capacitor on the primary of the transformer with a specific radiator length to further expand and reduce the SWR within the range of 80m-10m..
It is designed to be used without the use of a tuner, and after optimizing the driven element, SWR ≤ 1.2 for any part of the frequency band..
Package Included: 1 x Portable No Tune End Fed Half Wave Antenna.

Base station antenna, omnidirectional unity-gain extremely wide-band suitable for scanner use TX.
Type: disc one frequency range: RX band: 100-2000 MHz.
Gain: 0 dBd - 2.15 dBi, maximum power (CW) @ 30°c: 200 watts connector: SD 2000 n: n-female.

Base station antenna, omnidirectional unity-gain extremely wide-band suitable for scanner.
Transmission capability in several ham bands, perfect protection against the worst weather conditions.
Stainless steel hardware and radials equipped with anodized aluminum bracket for an easy side mast.
Gain: 0 dB - 2.15 dB, maximum power (CW) at 30°C: 200 Watts connector: SD 3000 U: UHF-female.

Wide-band receive: 25 to 1300mhz, specific transmit freq 144,220,440,900,1290 MHz.
55" vertical element frequency extender for low band operation.
Rust free all stainless steel structure, SWR 1.5:1 max.
Max power: 200 watts , 1-3/8"(35m/m) maximum mast diameter.

Base station antenna, omnidirectional unity-gain extremely wide-band suitable for scanner use transmission capability in several ham bands.
Type: disc one frequency range: RX band: 100-2000 MHz TX band (@ SWR .
Polarization: linear vertical gain: 0 dbd - 2.15 dbi @ lowest frequency max. Power (cw) @ 30°c: 200 watts connector: SD 2000 u: u-female, gold plated....
Materials: stainless steel, chromed brass, nylon wind load / resistance: 44 n @ 150 km/h / 150 km/h.

This 10FT PL259 jumper is used on CB ham radio, HF amateur radio, antenna, swr meter, analyzer, tuner, switch, monitor, Dummy Load. Also great for car....
High quality and 50Ω low loss, this uhf patch cable is made of tinned copper inner conductor with brass connector, which can resist oxidation and....
RG 58 coax cable, over 95% coverage. The braid shield is made of 96*0.12 * 0.14mm aluminum wire, low low and maximum protect the signal..
No obvise swr rising, after testing, this uhf coaxial cable does not introduce static nor interference when bridge the CB to SWR meter..
We offer worry-free warranty and friendly customer service within 12 months for your confident purchase. If you are not satisfied with any product,....