Reviews Servo Expander Board
10 pcs 3.93inch JR Style Servo Extension Cable Lead Wire - 3-Pin JR Plug Male to Male RC Servo Wire Extension Cord
- 3-Pin JR plug male to male connector servo extension lead wire cable..
- There is a 3 pin JST RE connector on each end. This is a simple 3 wire cable. Ideal for jumping from board to board, or something else..
- Practical range: For Airplane, Helicopter, Quad co-pterter , Multi-coater RC car servo connection or receiver connection..
- Packaging quantity :10 Pcs * 10cm JR 3pin male to male plug servo extension cables wires cords leads..
Check StockAITRIP 12PCS TCA9548A I2C IIC Multiplexer Breakout Board Module 8 Channel Expansion Development Board for Arduino
- The TCA9548A adapter is connected to an I2C device with multiple identical addresses on the same I2C port on the main control board for normal communication and use.There are 8 I2C interfaces on one expander, and there are eight bidirectional transfer switches that can be controlled by I2C bus. This means that after 1 expander is transferred, 8 identical addresses can be connected to the same I2C port..
- Expansion board TCA9548A compatible with IIC bus and system management bus (SMBus), active low reset input, support for hot insertion, low standby current, no glitch during power-up, support for voltages between 1.8V, 2.5V, 3.3V and 5V buses Level shifting, TCA9548A I2C IIC multiplexer breakout board depending on the contents of the programmable control registers, any single SCn/SDn channel or combination of channels can be selected..
- 12pcs TCA9548A I2C IIC Multiplexer Breakout Board 8 Channel Expansion Board for Arduino.
Check Stock15 Pcs Servo Extension Cable JST Y Connector 3 Pin JST Plug Splitters Male to Female Servo Adapter JST Extension Servo Wire Connector Compatible with RC JR Futaba RC Car or Airplanes, 3 Styles
- You Will Get: the package comes with 15 pieces of servo extension cables, including 5 pieces of male JST to female JR (Futaba) cable, 5 pieces of male to 2 female Y harness, 5 pieces of male to 3 female Y harness, sufficient quantities and multiple styles can satisfy your different using needs.
- Proper Size: the servo connector is about 15 cm/ 5.9 inches in length, suitable size for your to use, with colors of white, black and red.
- Wide Application: these JST plug splitters are compatible with Futaba and JR servo, plane and helicopter servo connection or receiver connection, also suitable for remote control car, RC car and so on, providing a lot of usages for you.
- Nice Craftmanship: the JST plug connector is made of quality PVC material, which has good insulation and flame retardant, and the interior is made of tinned copper, featured a good transmission and low resistance performance, you can rest assured to use it.
- Practical Function: the servo wire connector can be applied for jumping from board to board, or nice to control panel cable remote control part that is male to female.
Check StockMakerFocus PWM Servo Motor Driver IIC Module 16 Channel PWM Outputs 12 Bit Resolution I2C Compatible with Raspberry Pi 4 3B+ 3B Zero/Zero W/Zero WH and Jetson Nano
- Note: The Raspberry Pi and Servo in the photo are not included. User Manual: Please get the link from the operation guide below.
- Note: 1.If you only connect 5V power supply to USB interface, servo cannot be driven.
- 2.You should connect higher power supply for higher-power servo.
- 3.Make sure servo are connected properly, otherwise they will not move..
- Servo Motor Driver: You may have tried to control a robotic arm or a hexapod walker by using the Raspberry Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver Board for you..
- Raspberry Pi connectivity, compatible with Raspberry Pi 4 3B+ 3B 2B+ 2B Zero/Zero W/Zero WH and Jetson Nano..
- Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales).
- Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal..
Check StockDIYmall 10pcs 10cm 3.93inch Male to Male JR Plug Servo Extension Lead Wire Cable 3Pin 100mm for RC Plane
- 10CM Male to Male JR Plug Servo Extension Lead Wire Cable.
- Great for jumping from board to board or just about anything else..
- There is a 3-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers..
- Length:100mm Type:JR Plug Servo Extension wire (Male to Male).
Check Stockwaveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard
- Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
- Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
- 1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
- 10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
- Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.
Check Stock6Pcs ShareGoo JR Style Servo Splitter Cable, 2.75' Servo 1 Male to 2 Female JR Y Harness Y Cable Extension Wire for RC Models Car Airplane Helicopter Drone Boat
- Used for RC cars trucks airplanes helicopters rc boat servo connection, receiver connection and flight control board..
- This servo Y-cable allows you to control two servos with one radio channel..
- Material: 22AWG silicone wire.Wire Length: 7CM/2.75".
- 3Pin wire cable.Male JR plug to 2 Female JR plug Y Harness cable..
- Pack of 6 JR style servo splitter cable,unique design, professional quality JR style connectors..
Check StockTreedix TCA9548A I2C Multiplexer Breakout Board 8 Channel Expansion Board with pi Header for Arduino
- The TCA9548A Breakout board supports communicating with multiple I2C devices with the same address, making it easy to interface with them..
- TCA9548A multiplexer features: bidirectional eight-channel I2C multiplexer, active low reset input.
- The default address of this expander is 0x70, the address can be changed, and can be set within 0x70~0x77..
- In the address of 0x70~0x77, 8 expanders can be cascaded, and each expander can be connected to 8 devices with the same address, so that the same I2C port can be connected to 64 devices with the same address and can be used normally..
- The chip is compatible with 3V and 5V and can be used with any logic level.
Check StockArduino Uno 3 Ultimate Starter Kit Includes 12 Circuit Learning Guide
- This is the ultimate Arduino Uno kit enough to get you started with hundreds of arduino projects.
- Bread Board — Holder — Jumper Wires — USB Cable — LEDs — DC Motor — Small Servo — Relay.
- Includes a total of over 190 electronic parts and components.
Check Stocksb components Motor Driver Board for The BBC Micro bit 2 Channel DC Motors and 3 Channel Servos Motors Motor Driver for Micro bit BBC microbit Motor Driver Board
- micro:bit edge connector, directly pluggable.
- 2x DC motor interfaces, 3x servo interfaces.
- Integrates 5V regulator, up to 3A output current.
- Onboard multi connector options for DC motors in different specifications, onboard standard servo headers.
Check Stock