Reviews Rf Signal Strength Analyzer

Portable TinySA Spectrum Analyzer, SEESII Upgraded V0.3.1 Tiny Frequency Analyzer with Antenna SMA Male to UHF Female Cables, 100kHz to 960MHz MF/HF/VHF UHF Input, 2.8'' Touchscreen Signal Generator

  • 【Frequency Range 】Tiny Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz. Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz. Color display showing 290 scan points covering up to the full low or high frequency rangefrequency range. The tinySA contains all the components of a conventional heterodyne swept spectrum analyzer..
  • 【Built-in Calibration Signal Generator】When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration..
  • 【Tiny Spectrum analyzers】Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.Color display showing 290 scan points covering up to the full low or high frequency range. Bulit-in rechargeable battery allowing a minimum of at least 2 hours portable use..
  • 【PC Control】Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer.The USB interface implements the Serial over USB (CDC) protocol and there is a large set of commands that can be invoked over the serial interface. These co....
Check Stock

TinySA Spectrum Analyzer,Handheld Tiny Spectrum Analyzer TinySA 2.8inch Touch Screen,Portable Frequency Analyzer 0.1MHz~ 960MHz MF/HF/VHF UHF Input, Signal Generator with Battery

  • 【Input Frequency Range】Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz..
  • 【2-in-1】Built-in calibration signal generator that is used for automatic self test and low input calibration.When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz..
  • 【2.8inch Touching Display Screen】Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.Display resolution 320*240 pixels.Color display showing 290 scan points covering up to the full low or high frequency range.Scanning speed of over 1000 points/second using largest resolution filters..
  • 【PC Controlled 】Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer.Bulit-in rechargeable battery allowing a minimum of at least 2 hours portable use.*Resistive touch contro*Jog switch control*USB serial port control.
  • 【Package List】1x Tiny Spectrum Analyzer.
Check Stock

Portable TinySA Spectrum Analyzer,SEESII Upgraded V0.3.1 Handheld Tiny Frequency Analyzer 100kHz to 960MHz MF/HF/VHF UHF Input,Signal Generator with 2.8 inch Touch Screen with ESD Protect Function

  • 【Frequency Range 】Tiny Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz. Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz. Color display showing 290 scan points covering up to the full low or high frequency rangefrequency range. The tinySA contains all the components of a conventional heterodyne swept spectrum analyzer..
  • 【Built-in Calibration Signal Generator】When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration..
  • 【Tiny Spectrum analyzers & ESD Function】Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.Color display showing 290 scan points covering up to the full low or high frequency range. Bulit-in rechargeable battery allowing a minimum of at least 2 hours portable use.The performance of the 2021 latest version 3.1 will be more stable and sensitive, with a new ESD protrcted function enable the product to have a higher antistatic level and a longer service life..
Check Stock

1-600MHz RF Signal Power Meter Logarithmic Detector -74dBm to 18dBm Radio Frequency Detection

  • The detector is is used for RF signal power detection of frequency range between 1MHZ and 600MHZ.
  • It can detect a rf signal of power from -74dBm to 18dBm, and convert the RF signal into a DC voltage output.
  • The higher radio frequency signal range or power is, the higher output voltage will be.
  • output voltage is proportional to logarithm of input signal range.
  • Widely used for RF signal detection, signal power measurement, environment field strength detection, can also be used as a part of automatic gain control and automatic level control.
  • It can be made into 1mw ~ 1kw RF power meter after appropriate transformation.
Check Stock

Upgraded TinySA Spectrum Analyzer,Karagas Spectrum Analyzer Handheld,MF/HF/VHF Input for 0.1MHZ-350MHZ and UHF Input for 240MHZ-960MHZ,Portable Frequency Analyzer with 2.8 Inch Touch Screen V0.3.1

  • 003cp003e◙【003cb003eBuilt-in 2-in-1 Calibration Signal Generator003c/b003e】This TinySA Spectrum Analyzer built-in calibration signal generator that is used for automatic self test and low input calibration.When not doing spectrum analyzer,it can be used as signal generator with two frequency outputs,MF/HF/VHF sinus output for 0.1MHZ-350MHz and UHF square wave output for 240MHz-960MHz.003c/p003e.
  • 003cp003e◙【003cb003e Frequency Range003c/b003e】The 2.8-inch color touch screen displays 290 scanning points,covering the entire range of low-frequency or high-frequency ranging frequencies.0.1 MHz -350 MHz high quality IF/HF/VHF input,240 MHz -960 MHz low quality UHF input.A switchable resolution band-pass filter suitable for the range from 2.6 kHz to 640 kHz.003c/p003e.
  • 003cp003e◙【003cb003ePC Control003c/b003e】This spectrum analyzer can be connected to PC through USB and realizes the serial over USB (CDC) protocol,which can call a large number of commands.The Windows driver will be automatically installed after connecting to the Windows computer.The Linux driver is built into the kernel.003c/p003e.
  • 003cp003e◙【003cb003ePortable Spectrum Analyzer & ESD Protection Function003c/b003e】The latest version 3.1, new ESD protection function, insta....
Check Stock

Professional RF Cable TV Signal Amplifier with High 40dB Gain

  • ...g extremely low-noise figure and minimum distortion. Adjustable gain control and tilt control allows for easy system balancing..
  • Solution in solving the problems of noise, interference and weakness after distribution. Boost RF coax signal with ease for more than 1700FT or 500m if RF TV source signal has fair 70/75dB strength to start with. Boosts the existing CATV or antenna signal strength for greater distance with minimum loss for more TV distribution..
  • Adjustable gain/attenuation to reduce overdriving. Adjustable tilt compensation to allow large CATV systems to be properly balanced and mixed with other CATV or existing RF distribution system. Supports full TV frequency range from 40MHz to 860MHz for analog/digital cable TV, UHF and VHF channels. Anti-Interference module design with advanced noise filer built in..
  • -20 dB Output/Input Test Port is provided for easy trouble shooting. Thunder bolt protection with internal AC fuse built in for high voltage surge events. Aluminum chassis provides excellent heat dissipation and long durability..
Check Stock

EMF Meter,Advanced GQ EMF-390 Multi-Field Electromagnetic Radiation 3-in-1 EMF ELF RF meter, 5G Cell Tower Smart meter Wifi Signal Detector RF up to 10GHz with Data Logger and 2.5Ghz Spectrum Analyzer

  • Multiple high sensitivity sensors installed for detecting Power line, Smart meter, Cell phone, Microwave etc..
  • Identify/recognize the common possible sources, such as Power line, Cell Tower, Microwave, Static etc..
  • Safety suggestion lets you understand current situation instantly..
  • Detects 5G network signal and RF up to 10Ghz.
  • Built-in RF Spectrum analyzer and GQ RF Browser for real time RF monitoring..
Check Stock

Bindpo RF Logarithmic Detector, 1M-10000MHz AD8317 Radio Frequency Logarithmic Detector Power Meter, for RF Signal Power Detection/Radio Frequency Signal Detection

  • The product is designed by using AD8317 chip, and is used for RF signal power detection..
  • Can detect power in -55dBm to -0dBm of an RF signal, so that the RF signal is converted to DC voltage output..
  • The greater the amplitude or power of the RF signal, the higher the output voltage, and the output voltage is directly proportional to the logarithm of the input signal amplitude, thus expanding the dynamic range of the detected signal, which ranges reach 55dB..
  • It can be widely used in radio frequency signal detection, signal power measurement, environmental field strength detection..
  • It can also be used as part of automatic gain control and automatic level control..
Check Stock

YWBL-WH Logarithmic Power Detector Meter AD8317 1M-10GHz 60dB RF Power Meter Logarithmic Detector Controller for Amplifier 50 Ohms

  • AD8317 CHIP---The logarithmic power detector is designed by using AD8317 chip, and is used for RF signal power detection.
  • -55dBm to 0dBm---The logarithmic power detector can detect power in -55dBm to 0dBm of an RF signal, so that the RF signal is converted to DC voltage output.
  • APPLICATION AREAS---The logarithmic power detector could be used for RF transmitter PA set point control and level monitoring.
  • Power monitoring in a radio line transmitter.
  • RSSI measurements in base stations, WLAN, WiMAX, and radar.
  • 55dB---The greater the amplitude or power of the RF signal, the higher the output voltage, and the output voltage is directly proportional to the logarithm of the input signal amplitude, thus expanding the dynamic range of the detected signal, which ranges reach 55dB.
  • WIDE APPLICATION---The logarithmic power detector could be widely used radio frequency signal detection, signal power measurement, environmental field strength detection, or as a part of automatic gain control and automatic level control.
Check Stock

AD8317 Logarithmic Detector, RF Log Detector Logarithmic Detector, Logarithmic Detector RF Signal Log Output Power Meter 1M-10000MHz Controller

  • [Main function]: This logarithmic detector is designed for ADI's AD8317 chip and is used for RF signal power detection..
  • [Detection frequency range]: The detection frequency range of the logarithmic detector is 1M-10GHz, and it can detect RF signals with a power of -55dBm to -0dBm, and convert the RF signal into a DC voltage output..
  • [Excellent performance]: The greater the RF signal amplitude or power, the higher the output voltage, and the output voltage is proportional to the logarithm of the input signal amplitude, which will expand the dynamic range of the detected signal by 55dB..
  • [Wide use]: The logarithmic detector is widely used in radio frequency signal detection, signal power measurement, environmental field strength detection, and can also be used as a component of automatic gain control and automatic level control..
  • [Stable and durable]: This logarithmic detector can withstand high and low temperatures, is stable and durable, with a temperature measurement range of 0°C to 1024°C, and a converter temperature resolution of 0.25°C..
Check Stock