Reviews Power Isolation

USB Isolator ESD Protection Ground Loop Isolator ADUM3160 Only USB 2.0 Full/Low Speed up to 1W Power

  • Remove ground loops, protect PC, eliminate humming noise.
  • Signal isolation up to 2.5KV, power isolation up to 1.6KV.
  • Supports USB 2.0 Full/Low Speed, ⚠ USB 2.0 High Speed Devices are not supported ⚠.
  • Up to 1W load capacity, ⚠ not for charging or devices drawing over 180mA.
  • Uses ADUM3160 IC for signal and B0505S for power isolation.
Check Stock

High Frequency Transducer, Mixer Module 0.1‑500MHz Bandwidth Mixing for HF VHF Receiver for Quadrature Modulation for Base Station

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

Mixer Module, Bandwidth Mixing 0.1‑500MHz High Frequency Transducer -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
Check Stock

UMI AV250 Isolation Transformer 250W Noise Filtering and Surge Suppression and Power Clean 2 Outlet

  • 1. Power Clean: Complete line isolation, Eliminate EMI/RFI line noise and provide clean power for sensitive equipment.
  • 2. Isolation Transformer: Toroidal transformer and Faraday Shield, reduce the static interference from the wall outlet.
  • 3. Power supply: 120V AC input and 120V AC output.
  • 4. 2 outlets: allow to use 2 equipment at same time and a power strip for more.
Check Stock

Frequency Converter AD831 Single Chip High Frequency RF Mixer Radio Frequency Conversion Module for HF and VHF Receiver, 0.1-500MHz

  • WITH VARIOUS PORTS-- There is no corresponding shielding and isolation problems, therefore, compared with the passive mixer to improve the performance of the system, reduce the system cost. The mixer is designed as a single power supply, RF, IF and LO ports with DC isolation capacitor, easy to use..
  • POWERFUL-- The operating frequency of the RF and LO inputs can be as high as 500MHz. IF output is single ended voltage output. With 250 MHz output bandwidth. A single resistor connected between pins OUT and FB is used to set the gain..
  • EASY TO USE-- When the mixer's output amplifier and the optimum source impedance, the SSB noise figure of the mixer is 10.3dB at 70MHz. Different from the passive mixer, there is no insertion loss, no need external duplex device, and no need passive termination for AD831..
  • APPLICATION-- The AD831 is a low distortion, wide dynamic range, single chip mixer, suitable for HF and VHF Receiver RF-IF frequency, second mixer in DMR base sta....
Check Stock

Tripp Lite IS500HG Isolation Transformer 500W Medical Surge 120V 4 Outlet TAA GSA

  • Complete line isolation, noise filtering and surge suppression.
  • 500 watts, 4 5-15R-HG hospital outlets, 10-ft. power cord with NEMA 5-15P-HG plug.
  • Internal low-impedance isolation transformer with Faraday shield offers 100% isolation from the input AC line.
Check Stock

Tripp Lite IS1000HG Isolation Transformer 1000W Medical Surge 120V 4 Outlet TAA GSA

  • Complete line isolation, noise filtering and surge suppression.
  • 1000 watts, 4 5 15R HG hospital outlets, 10 feet power cord with NEMA 5 15P HG plug.
  • Internal low impedance isolation transformer with Faraday shield offers 100 percent isolation from the input AC line.
  • Floating AC output prevents noise coupling.
Check Stock

Donner DPA-100 Guitar Pedal Power Supply Adapter 9V DC 1A Tip Negative 5 Way Daisy Chain Cables for Effect Pedal

  • 【9V ADAPTER】OUTPUT: 9V DC, 1A (1000mA), Tip Negative (-) design .INPUT: AC100V-240V, 50-60Hz, 9W.
  • 【live for music.】Stable power supply circuit design, enough power for guitar pedals..
  • 【5 way power chain cables 】5 way cable chain could power on 5 pedals at the same time.
  • 【Fit for Guitar Pedals】Fit for most brands of guitar effect pedals.
  • 【Professional noise isolation performanc】- High quality copper core daisy chain cable with special anti-hum. The professional noise isolation....
Check Stock

Tripp Lite IS1800HG Isolation Transformer 1800W Medical Surge 120V 6 Outlet TAA GSA

  • Complete line isolation, noise filtering and surge suppression.
  • 1800 watts, 6 5-15R-HG hospital outlets, 10-ft. power cord with NEMA 5-15P-HG plug.
  • Internal low-impedance isolation transformer with Faraday shield offers 100% isolation from the input AC line.
  • Leakage less than 100 microamps. Total harmonic distortion-Less than 1%.
Check Stock

Intona USB 2.0 Hi-Speed Isolator Standard Version Black 1.000VRMS

  • New: auxiliary power input The secondary side may be powered by an external power feed with up to 2000mA for energy-hungry devices via Micro-USB. The....
  • Provides galvanic isolation to the USB bus.
  • Compliant to USB 2.0 Hi-Speed (480 MBit/s).
  • Isolation withstands 5kVrms, Advanced ESD protection (20kV).
Check Stock