Reviews Nozzle Valve Injector Part

Ultimate Washer Adjustable Soap and Chemical Injector Pressure Washer, 3/8-Inch, 4000 PSI, 2-5 GPM

  • Soap and Chemical Injector, 200 Degree, 4000 PSI, 2-5 GPM.
  • Works with Standard3/8-Inch Quick Connect Pressure Washers.
  • Pressure Washer Chemical Injector Kit Includes Injector, Tubing and Filter.
  • Black Soap Nozzle (not included with kit) is required for proper operation. Great for Cleaning or Spraying, Compatible with Most Brands.
Check Stock

Injector Pressure Regulator Valve - IPR Valve - Compatible with Ford Trucks - Powerstroke 6.0L Diesel - E-350, Excursion, F-250, F-350 Super Duty - Replaces 5C3Z9C968CA, CM-5126, 5C3Z-9C968CA, AP63417

  • Replacement Injector Pressure Regulator Valve - regulates the oil bypass circuit of the high pressure oil pump. It is an electromagnetic valve that opens and closes to allow high pressure oil into the injectors. This enables the PCM to control fuel delivery by increasing the speed in which the IPR valve operates thus, being a critical component in your vehicle system..
  • Compatible Replacement for Ford 6.0L Vehicles - 2005 E350 Club Wagon | 2005 - 2010 E350 Super Duty | 2005 Excursion | 2005, 2006, 2007 F250 Super Duty | 2005, 2006, 2007 F350 Super Duty |. The injector pressure regulator valve can be located after removing the intake and the fuel filter housing above the engine which can be seen attached to the high pressure oil pump (HPOP)..
  • Replaces Part# 5C3Z9C968CA, 1846057C1, CM-5126, 5C3Z-9C968-CA, AP63417 - commonly found on popular F-250, F-350 Super Duty, E-350 and Excursion models with 6.0L V8 Diesel Powerstoke Engines including years 05, 06, 07, 08, 09, 10. If you are experiencing no or hard starting when the engine is hot or after stalling and usually starts when it is cold or your vehicle is idling erratically or jerking then you may have a problem with your IPR valve..
  • OEM Fit, Quality, Finish - While this is not a genuine OEM part, this inj....
Check Stock

Tempono Pressure Washer Soap Injector Downstream Injector for Pressure Washer Power Washer Chemical Injector Kit 4000 PSI 3/8 Inch Quick Connect

  • Pressure chemical injector ensures that chemicals do not pass through the pump. Protect the performance of the pump and extend its service life..
  • Chemical injector kit has 10 ft tube, soap injector, filter, nozzle and teflon tape. Max pressure is up to 4000 PSI..
  • Chemical injector has an metering valve. You can control the concentration of the liquid. Flow rate is 2 to 5 GPM..
  • Downstream injector for pressure washer with 3/8 inch quick connector. Please pay attention to mark of arrow direction on injector, do not install it....
  • The coupler is made of stainless steel and brass, sturdy and durable. Siphon hose is made of high-quality PVC, suitable for hot and cold water..
Check Stock

M MINGLE Adjustable Chemical Injector Kit for Pressure Washer, Soap Injector, 3/8 Inch

  • ★Attention: Max pressure is 3200 PSI. Pressure washer downstream chemical injector kit includes chemical injector, 10 feet tubing (siphon hose), filter and black soap nozzle..
  • ★Used to siphon detergent out of separate container. The chemical or soap runs after pump, which will not damage pump. Great for cleaning or spraying..
  • ★Control metering valve to adjust dilution ratio of chemical and water. Chemical-resist and poly strainer reduces injector clogging..
  • ★Soap injector has universal 3/8’’ quick disconnect. It connects between pressure washer pump and hose..
  • ★Flow rate is from 2 GPM to 5 GPM. Works with most brands of gas and electric pressure washer, cold and hot water pressure washer..
Check Stock

Tool Daily Adjustable Soap Chemical Injector for Pressure Washer, 3/8 Inch Quick Connect

  • ATTENTION: Working pressure is 1000 to 2800 PSI. Flow rate is from 2 GPM to 5 GPM. 2800 PSI or higher will not work. Power washer chemical injector kit includes chemical injector, 10 Feet tubing, filter and black soap nozzle..
  • Application: Must Follow Manual to Set Up Chemical Injector. It is used to siphon detergent out of separate container. The chemical runs after pump. So it allows for a wider choice of chemicals..
  • Chemical injector has standard 3/8’’ quick connect fitting. It connects pressure washer pump to hose..
  • Dilution ratio of chemical vs water can been adjusted by controlling metering valve..
  • Works with most brands of gas and electric pressure washer. Suitable for cold and hot water pressure washer..
Check Stock

Tool Daily Compatible Chemical Injector Set for Pressure Washer, Replacement for Briggs and Stratton 190593GS 190635GS 203640GS

  • Pressure Washer Soap Injector Kit, compatible Briggs & Stratton Pump 190593GS, 190635GS and 203640GS. Please identify the part number of pressure washer pump, then check if it fits your pressure washer..
  • How to replace: Follow soap hose to end and you’ll find injector. Take off soap hose. Use wrench to remove old injector. Clean out any gunk or dried soap in receptacle. Make sure rubber o ring is on injector as pictured. Put ball bearing inside injector and then the spring with small end of spring against the ball bearing. Insert injector into receptacle and tighten injector with 13mm wrench. Don’t overtighten, you’ll break the o ring or crack white metal on pump. Put the soap hose back on..
  • If the part on your pressure washer part is worn-out, rusted or hard-water-deposit clogged, you can replace it with this set..
  • Package List: Two Chemical Injector Sets, including 2 Brass Barbs, 2 Check Valve Balls, 2 Springs, 4 O-Rings..
Check Stock

Raincovo Downstream Injector for Pressure Washer Power Washer Chemical Injector Kit Soap Injector 3/8 Inch Quick Connect 4000 PSI

  • Package: Kit Includes chemical injector, 10 feet siphon hose, filter, black nozzle soap with 1/4” quick connect and teflon tape..
  • Application: When detergent is sucked out separately, the chemical will not pass through the pump, you could use a variety of chemicals without....
  • Characteristic: Chemical injector kit with a metering valve, which can adjust dilution ratio of soap and water. Avoid clogging of the injector and....
  • Connector: Downstream Injector has 3/8 inch quick connect. Fits most electric and gas power washer..
  • Material: Siphon hose is made of high-quality PVC, used for hot and cold water. Adapter is made of brass and stainless steel. Max pressure is 4000....
Check Stock

Set of 6 Performance 4-Hole Upgrade Fuel Injectors For 99-04 4.0L Jeep Cherokee 0280155784

  • Manufacturer Part Number: 0280155784 / Interchange Part Number: 280155784 , 4854181 , 4667938 , RL669938AB , FJ570 , FJ454 / Other Part Number: 1999 2000 2001 XJ TJ WJ EV6 4 Nozzle Wrangler.
  • Car Fitement: for ALL 1999 to 2004 Jeep Cherokee Grand Cherokee and Wrangler with 4.0 L, Six Cylinder Motor.
  • High performance fuel injector, meets or exceeds OEM standards, 100% tested before shipping.
  • Please check your correct replacement parts before purchase, the picture show more detail.
  • Package including: 1 x set of fuel injector.
Check Stock

DOMINTY Non-Dismantle Injector Cleaner&Tester Fuel System Adapter Kit For Petrol EFI Throttle Car 600ML Tank 120PSI

  • – This is our brand new automotive non-dismantle fuel system cleaner injector clean set for petrol cars. When the car starts to be unstable, idle and difficult to start, at the same time fuel consumption increases, this may be due to carbon deposition–residual deposit happening in the fuel system, which could affect normal work. Our cleaner kit will help you out with simple and fast cleaning..
  • – This injector clean kit includes many different adapters, thus covering almost all the EU, Asia, USA cars and light trucks..
  • – The system not only features with high and low pressure cleaning function. At the same time it could also clean the whole fuel system including throttle valve, fuel nozzle and combustion chamber..
  • – Fit for gasoline injector,not for diesel injector..
Check Stock

RIDGE WASHER Compatible ChemicalInjector Set for Pressure Washer, Replacement for Briggs and Stratton 203640GS 190593GS 190635GS

  • Package: two chemical injector sets include two brass barbs with 1/8 inch-27 male BSP thread, two check valve balls, two springs and four o-rings..
  • Compatible: Pressure washer soap injector kit is compatible with Briggs & Stratton Pump 190593GS, 190635GS and 203640GS. Please check the part number of your pressure washer pump and make sure the soap injector matches your pump..
  • Function: If the part on your pressure washer pump is worn-out, rusted or hard-water-deposit clogged, you can replace it with this set..
  • Attention: When you insert injector into receptacle of pump and tighten injector with 13mm wrench, don’t overtighten, you’ll break the o ring or crack white metal on pump..
  • If you have questions, contact us at any time. We provide a service of quick reply within 10 hours. Welcome to RIDGE WASHER to see other pressure washer accessories..
Check Stock