Reviews Mb Carsoft7 4 Multiplexer New

Installer CCTV 4CH Video Color Quad Multiplexer with Loopout Remote Control and Free 1 Amp Power Adapter

• The 4Ch Video Color Quad Multiplexer allows several video signals from CCTV security cameras or other analog video devices to be combined and displayed on one monitor. The video processors are also commonly referred to as video mux, CCTV multiplexer, or color quad processor..
• Full screen displays at real-time refresh rate for each channel. Multiple and automatic display by turn mode: 4Ch, 2Ch, Single Channel.
• Camera title, time and date display for easy identification, 4 Channel BNC input and 2 Video BNC outputs.
• Switch between NTSC and PAL system. Picture in Picture show, PIP position switched (top left, top right, bottom left, bottom right corner). High-Resolution Picture show, Adjust individual resolution. High-quality Screen Freeze function..
• Free 1Amp Power Adapter and remote control Included.

20Pcs HEF4051BT SOP-16 HEF4051B SOP16 F4051B 8-Channel Analog multiplexer/demultiplexer

6pcs CD74HC4067 CMOS 16 Channel 16 CH Digital Analog Multiplexer Breakout Module for Arduino

• This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067..
• Use the CD74HC4067 16-channel analog signal switch.
• Analog signal input: C0-C15 16 channels..
• IT can be used the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067..
• Wide operating temperature range: -55C to 125C.

Analog/Digital MUX Breakout for Arduino

• 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067.
• ON Resistance 70Ohms @ 4.5Vcc and 60Ohms @ 6VCC.

100PCS CD4053 CD4053B CD4053BE DIP-16 Analog Multiplexer IC

• It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
• The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
• Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
• This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
• Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..

Analog Multiplexer Single 8:1 ñ9 Volt 20 Volt 16-Pin Plastic DIP Tube

• The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
• It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
• Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
• Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
• This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..

Treedix TCA9548A I2C Multiplexer Breakout Board 8 Channel Expansion Board with pi Header for Arduino

• The TCA9548A Breakout board supports communicating with multiple I2C devices with the same address, making it easy to interface with them..
• TCA9548A multiplexer features: bidirectional eight-channel I2C multiplexer, active low reset input.
• The default address of this expander is 0x70, the address can be changed, and can be set within 0x70~0x77..
• In the address of 0x70~0x77, 8 expanders can be cascaded, and each expander can be connected to 8 devices with the same address, so that the same I2C port can be connected to 64 devices with the same address and can be used normally..
• The chip is compatible with 3V and 5V and can be used with any logic level.

InstallerCCTV Video Quad Color 4CH Multiplexer 2 BNC Output with Remote Control and Free 1Amp Power Adapter…

• Full quad display at real-tme refresh rate.
• Camera title, time and date display for easy identification, 4 Channel BNC input and 2 Video BNC outputs.
• Free 1A Power Adapter and remote control Included.

OEM Nexperia 74HC4067PW,112, Analog Switch/Analog Multiplexer Single 16:1 24-Pin TSSOP Bulk (100 Items)

• Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
• This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
• The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
• It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
• Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..

Bridgold 20pcs SN74HC14N 74HC14 SN74 Hex Schmitt-Trigger Inverters 2V to 6V,DIP-14.

• The most popular 74LSx series IC chip kit..
• There are 2 models for each model, a total of 20, placed in a convenient box..
• A new product that is capable of meeting the data requirements at work..
• 74LS00 2 input four NAND gate, 74LS02 2 input quad NAND gate, 74LS04 six inverter..
• 74LS138 3-8 line translator / multiplexer..