Reviews Maytag Furnace Ignitor

Duralight Furnace Hot Surface Ignitor Direct Replacement For Goodman Amana Janitrol OEM Part B1401018

❤【PERFECT FIT】- 62-22868-93 hot surface ignitor is perfectly compatible with Rheem, Ruud, and Weatherking furnaces (NOTE: Not To Fit -gec or -ged "drum" Heat Exchanger Type Furnaces).
❤【REPLACEMENT MODEL】- 62-22868-93 furnace ignitor replaces part number 62-22441-01, 62-22548-01, 62-22868-01, 62-22868-02, 62-22868-82, 62-22868-92, 62-22868-93S, 62-22869-01, 62-23460-01, 8553-5514 (Contact us if you are not clear the compatibility, and we are here to help within 24 hours).
❤【EXCELLENT PERFORMANCE】- The 62-22868-93 furnace hot surface ignitor with wire connectors is used to light the oven burner and adjust the temperature normally. It fixes the symptom that the oven failing to heat or not heat properly. Use this high-quality replacement part to extend the life of the oven.
❤【PREMIUM QUALITY & EASY INSTALLATION】- Our 62-22868-93 furnace ignitor for rheem is made of durable and high-quality materials well-tested by the manufacturer, with higher heat resistence, durability and the best quality for greater power connection, higher load and longer service life. ⚠️It is fairly easy to install. If wire connector does not match up you will need to cut off the connector and splice the wires with porcelain wire nuts.

Genuine OEM Replacement for Goodman and Amana units..
The 0230K00001 mini ignitor replaces outdated part numbers B1401018, B1401015, B1401009, B1401009S, and B1401018S..

Replacement for numbers 0230K00001, IGN02004, B1401015S, B1401018S and AP4514330.
Designed to fit specific Goodman manufactured furnace models including Amana and Janitrol.

The wire leads measure 8" long to end of plug..
It is a replacement part number 501A, Maytag and Whirlpool Numbers 74007498, 7432P106-60, AP4096256, PS2085070..

120 volt nitride furnace igniter Replaces hot surface ignitor for gas-fired furnace, boiler, and water heater.
How to tell if your igniter is working， if the igniter has continuity your multimeter should read anywhere from 9 to17 Ohms,if there is no reading on the multimeter or very little change, then there is no continuity and you will have to replace the nitride furnace igniter.
1.97" Nitride heating element, 1.18"Ceramic insulator body nonglazed 95% alumina- polished finish, 15-3/4 inch temperature rating 250℃ cable- 20 AWG/ UL 10362 specification.
It works compatible with Cook Top, Cook Top and Range, Furnace and Warm Air Movement, Gas Ignition, Hot Surface Igniters, Infrared light source, Pool Heater and Boilers, Process Machinery, Special FX, Water, and Parking Heaters Nitride heating element.
Power rating:150 W. Temperature at 120v ± 0.5v .60HZ at 17 sec ≧1180 ℃.This is a very versatile product, very robust with long cycle life. Silicon nitride is extremely rugged and can be handled without fear of breakage or contamination..