Reviews Industrial Thermostat

HEATIT HISD 18-feet Pipe Heating Cable with Built-in Thermostat

  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat

  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 12-feet Pipe Heating with Built-in Thermostat, Black

  • ...ng grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black

  • ...ng grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

DEWENWILS Roof Heat Cable, 6ft Heat Tape for Pipe, Gutter, Roof, Self-Regulating Cable Pre-Assembled, UL Listed

  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

Qmark WHT500 Utility Heater for Use in Well Houses, Utility Rooms, and Areas with Pipes and Machinery, 500 Watt, 240 Volt, Beige

  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

Caframo Limited Cabinet Heater-2 Settings, Black

  • Certified for industrial and commercial use only..
  • 500 Watts, preset thermostat, compact design.
Check Stock

TEMPWARE Electric Garage Heater, 5000-Watt Ceiling Mount Shop Heater with 3 Heat Levels, 240-Volt Hardwired Fan-Forced Industrial Heater, Ideal for Workshop

  • ... output. Its maximum BTUs of 17,060 is powerful enough to heat a large area up to 592 square feet. Power ranges from low to high, 3,000 watts, 4,000 watts, and 5,000 watts to meet your different needs.
  • Space Saving Design: This is an ideal compact garage heater with almost industrial-strength power. It can be stably placed on the ground or mounted on a wall or ceiling, which is very suitable for factories,workshops and warehouses to save precious space.
  • Safe & Sturdy Structure: Our electric garage heater is made of heavy-duty steel material, which is very strong and durable, and has a long service life. In addition, the heater for workshop is ETL certified to ensure your safe use.
  • Thermostat & Overheat Protection: Our garage heater is equipped with a built-in thermostat. You can adjust the thermostat to suit your needs and preferences (from 45°F to 95°F). And a built-in sensor switches the device off automatically if it overheats.
  • Hardwired Installation: You will need an electrician to do this safely. The garage heater must be grounded and hardwired to a properly sized cu....
Check Stock

WHDTS Digital Temperature Controller Switch Module 12V DC -50℃ to 110℃ Micro Digital Thermostat Board with 1M Waterproof Sensor Probe

  • HIGH AND STABLE QUALITY: The digital temperature controller is equipped ST core chip, high-precision temperature control sensor probe and 1.8mm ABS shell which has good toughness and low temperature resistance..
  • TEMPERATURE CONTROL MODE: Our electronic temperature control module can be choosen heating or cooling mode to meet your needs. The digital thermostat also has power off memory function..
  • TEMPERATURE RANGE: The temperature measure and control range is -50~110℃, the accuracy is 0.1℃..
  • WATERPROOF AND ELECTRICITY PROOF PROBE: Our 1 meter probe has Stainless steel shell, sealed with resin, waterproof and no rust and electrical isolation design. it’s very weak even if there leakages, very safe to use..
  • WIDE APPLICATIONS: The size is 2.2*1.5*1.2 inches. After setting the mini embedded thermostat, it can be appled to chassis cabinet, pet house temperature control, computer case, refrigerator freezer and more household appliances and Industrial equipment..
Check Stock

DC 12V Electronic Temperature Controller Programmable -50 to 110 Degree Celsius Heating/ Cooling Thermostat Control Switch Module NTC Waterproof Sensor Probe Dual Color LED Display Monitor 2 Pieces

  • What will receive: you will get 2 pieces of DC 12V 200 mA temperature controllers, the measurement temperature is from -50 to 110℃(-58 to 230℉),....
  • Dual color LED display: this digital thermostat control module of dual color LED display, which show the measured temperature (red) and set....
  • Waterproof design: the NTC (10K 0.5%) probe is waterproof, and you can control the temperature at will, can also control heating or cooling according....
  • Reliable to use: the electronic temperature control switch module has been tested for consistency and reliability, and its control accuracy is 0.1....
  • Wide application: the electronic thermostat can be widely applied in intelligent home and industrial equipment, suitable for household appliances,....
Check Stock