Reviews Capacitor Factory - BestBuyersPro.com

Audio Amplifier Board, DROK 5W+5W Mini Amplifier Board PAM8406 DC 5V Digital Stereo Power Amp 2.0 Dual Channel Class D Amplify Module for Speaker Sound System DIY

...audio amplifier board working voltage is DC 5V, output power is 5W (2Ω 5V)/3W (4Ω 5V) / 1.8W (8Ω 5V). Input method is monaural input..
Artificial Material: this New-designed mini power amplifier is made of noble black immersion gold circuit board, imported KEMET speaker capacitor, large-capacity filter capacitor for channels. Besides, we customized black copper terminal blocks and gold-plated audio input terminal blocks for this new amplifier module..
High Performance: the digital amplifier module is with high efficiency of over 90%, general harmonic distortion noise is less than 10%, low quiescent current and noise suppression..
Safe Protection: the class D dual-channel amp board is designed with input reverse connection protection, short circuit protection, over heat protection.
Additional Function: it is available to connect amplifier type to choose different function (MODE: high electricity level is Type D, low electricity level is Type AB. Factory defaults high electricity level).
available to add an external Shutdown (SD: the chip....

Factory Antenna to Aftermarket Radio Adapter.
For select 1988-2005 Audi/BMW/Mercedes vehicles.
Factory antenna with flat plug to aftermarket radio.
A capacitor is included to match impedance.
Some newer European radios also have capacitors that do not allow this adapter to work properly (try using 40-VW12).

1/2 HP Transfer pump moves up to 1500-gallons per hour.
Continuous duty, thermally protected split capacitor motor.
Includes: brass garden hose adapters, suction strainer, and an additional set of motor brushes.
Features: 3/4-inch NPT suction and discharge.
Built-in carrying handle (NOT recommended for use as a sprinkler pump or booster).
Rugged cast iron construction for durability.
Uses: drain water heaters, fill radiant heating systems, and general water transfer.
Superior Pumps are Built to Last, engineered with quality components and are 100% factory tested.

This 3 in 1 start kit is for compressors with horse power of 1/12 through 1/5. 110 to 125VAC. Totally pre-wired.
Solid state relay and overload start capacitor. Replaces 3 electrical components. Works on domestic and commercial refrigerators..
All Our Parts Are Factory Approved For A Proper Fit.
This is the non-original aftermarket parts.

This MESR-100 V2 auto-ranging capacitor ESR and low Ohm meter measuring range is 0.001-100.0R, support in circuit testing..
It is the series resistance inside the capacitor, and 100kHz is used to remove the impedance 1/(2*pi*F*C). When the impedance becomes smaller, the real series resistance value can be measured to determine whether the capacitor is bad/damaged or in good condition..
Our ESR meter only applies less than 15mV DC or peak to peak on a good capacitor, as a result we can use it as in circuit test..
During repairing TV, LCD, Audio board, etc. we can in circuit testing the capacitor is good or not.【Note:The Capacitance Meter is used for testing the internal resistance of the capacitor, not for testing capacitance value.】.
Dual terminal, for fast and easy inspect general capacitor or resistor, a printed ESR table for fast check.Equipped with a SMD alligator clip for more accurately testing..

The Supco Capacitor Tester is a genuine OEM (Original Equipment Manufacturer) part designed and engineered to exact specifications.
Supco Capacitor Tester provides the fastest measurements of capacitor values with one hand operation.
Supco MFD10 has accuracy ± 5% and range of 0.01 to 9,999 MFD.
The high quality Supco Capacitor Tester includes soft carying case for easy transport of device and test clips.
Repair your appliance with confidence when you choose Supco Capacitor Tester.