Reviews Bias Voltage

ANCEL BST200 12V Car Battery Load Tester with ANCEL PB100 Automotive 12/24V Circuit Tester Probe

  • Includes: 1 x BST200 Battery Tester, 1x PB100 Circuit Tester.
  • Works on automotive 12V 100 - 1100 CCA lead-acid batteries, including regular flooded, AGM flat plate, AGM spiral, and GEL batteries for cars, SUV, motorcycle, light truck, and more..
  • Gives you an accurate result in only 3 seconds, such as CCA value, CCA rating, voltage, internal resistance, state of health, and state of charge, based on the rating standard of CCA, CA, MCA, JIS, DIN, IEC, EN and SAE..
  • A MUST-HAVE TOOL - Designed for voltage & polarity testing, continuity testing, signal circuit testing, supply power/activating components, trailer lights & connections testing. It features red/green polarity indicators, follows & locates short circuits, and checks bad Ground contacts..
  • 4 WORKING MODES - DC Voltage mode for reading the DC voltage with a resolution of 0.1 volts.
  • AC Voltage mode for reading the Max. voltage, the Min. voltage, and frequency.
  • Resistance mode for reading the resistance between the tip and auxiliary ground lead.
  • Diode mode for checking forward bias or reverse bias..
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 3)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 10)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

ANCEL BA101 12V 100-2000 CCA 220AH Automotive Battery Load Tester with ANCEL PB100 Circuit Probe Vehicle Diagnostic Volt Meter 12V/24V AC/DC Resistance Detector

  • Includes: 1x BA101 Battery Tester, 1x PB100 Circuit Tester.
  • Small compact design, fast scan and direct test results display are some of BA101’s benefits. It’s a simple and easy yet quick and accurate tool for analyzing the health of a 12V battery. It tells you everything about battery’s voltage, charge, cranking power, and how much life is left of it (level of Ohm resistance)..
  • It checks the alternator's charging and starter's cranking conditions. Vehicle charging system test is also available, including load voltage, unloaded voltage, ripple status and charging system status..
  • A MUST-HAVE TOOL - Designed for voltage & polarity testing, continuity testing, signal circuit testing, supply power/activating components, trailer lights & connections testing. It features red/green polarity indicators, follows & locates short circuits, and checks bad Ground contacts..
  • 4 WORKING MODES - DC Voltage mode for reading the DC voltage with a resolution of 0.1 volts.
  • AC Voltage mode for reading the Max. voltage, the Min. voltage, and frequency.
  • Resistance mode for reading the resistance between the tip and auxiliary ground lead.
  • Diode mode for checking forward bias or reverse bias..
Check Stock

Juried Engineering TL072CP TL072 IC JFET Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 5)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL072CP IC Dual Low-Noise JFET-Input Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Comparator Dual177;18V/36V 8-Pin SO N T/R

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Texas Instruments LM311P LM311 Differential Comparator With Strobes DIP8 5 Pack

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock

Juried Engineering LM319N LM319 High Speed Dual Comparator Breadboard-Friendly (Pack of 5)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

Juried Engineering LM393P IC Dual Differential Comparator & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 1)

  • Wide range of supply voltage Maximum rating: 2 V to 36 V, Low input bias current, Low output saturation voltage.
  • Low supply-current independent of supply voltage: 200 µA per comparator, Low input offset voltage.
  • Common-mode input voltage range Includes Ground, Output compatible with TTL, MOS, and CMOS.
  • Differential input voltage range equal to maximum-rated supply voltage: ±36 V, Example Applications: Vacuum robot, Single phase UPS, Server PSU, Cordless power tool, Wireless Infrastructure, Appliances, Building Automation, Factory automation & control, Motor drives, Infotainment & cluster.
Check Stock