Reviews Axle Center Assy - BestBuyersPro.com

BORLA 140680 Exhaust System

Borla 140680 S-Type Cat-Back Exhaust System.
Incl. Front Pipe Assy/Muffler Assy/Tailpipe Assy/Polished 4 in. Single Round Rolled Angle-Cut Tip.

?IMPROVE DURABLILITY?Modified for heightened and widened front and rear drive shafts, which is better than ordinary axles, and the axle is higher. The....
?HIGH QUALITY?The aluminum alloy shell, hardened steel structure gears and drive shaft increase durability, and improve service life..
?INCREASE SPACING?The portal axles create extreme amounts of ground clearance under the center of its axle center, increasing the spacing by about....
?SIMPLE INSTALLATION?Easy to install, perfect fit, make your remote control car cooler and more attractive..

EASY TO USE: Slide flat end of puller through center of bearing and flat against backside of bearing, then slide washer down the center of the shaft against front side of bearing and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out.
The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage.
Use the VCT Pneumatic SAE Standard Rear Axle Bearing Puller 3-Piece Service Set – Domestic Car Vehicle Bearings Removal Tool Kit to service semi-floating rear axle bearings on your vehicle.
These tools make the job simple and prevent damage to your bearings when pulling.
Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings.
For removal only, not intended for installation.
FITS YOUR CAR: Standard SAE sizes work for most American domestic makes and models.
Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches.
Sizes permanently laser-etched on tool for easy identification.
Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch.

Ideal for use on the drive axle when paired with the NT555G2 on the non-drive axle.
Sidewall construction has been modified to improve launch.
Large twin center ribs provide a continuous contact patch for dry traction..

Ideal for use on the drive axle when paired with the NT555G2 on the non-drive axle.
Sidewall construction has been modified to improve launch.
Large twin center ribs provide a continuous contact patch for dry traction..

Build your own high-center cart with a set of these 20-Inch spooked wheels heavy-duty construction will handle the roughest terrain ball bearing axle.
Heavy-duty construction will handle the roughest terrain.

Kit contains: 2 ball bearings and 2 double lip seals which are positioned in the center axle carrier.
Honda TRX400EX Rear Axle Bearings and Seals Kit 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 **Does not fit aftermarket carriers that use wider bearings..