Reviews Analog Output

4K HDMI to Optical Audio Converter + HDMI PCM 5.1 7.1 to Analog Surround Decoder

  • Great digital to analog audio decoder solution for transcoding uncompressed digital LPCM 7.1 or 5.1 channel sound into analog surround format for existing analog amplifier or receiver. Extract compressed digital Bitstream audio such as Dolby Digital, AC3 and DTS 5.1/7.1 embedded in HDMI feed and output through its optical audio output for further decoding by downstream device. Supports uncompressed LPCM 7.1, LPCM 5.1 and PCM in analog output through the multi-channel 3.5 output ports..
  • Deliver 7.1 and 5.1 discrete channels through its front left/right, center/subwoofer, rear left/right and rear center left/right channel to deliver a directional and more realistic effect Supports compressed audio such as Dolby Digital, AC3, DTS 5.1 and PCM 2CH through optical audio output. Easy EDID dip switch selection so users can easily control their HDMI source to send the desired digital audio format for decoding or conversion..
  • No HDMI output with TV is required when receiving audio at the analog or optical audio output. Supports all HDTV resolutions including 4K, 2K, 1080p, 1080i, 720p, 576p and 480p. Output resolution follows input. Fully compliant with HDMI 1.3, HDCP 1.2 and DVI 1.1 standards..
  • Supports HDMI audio sampling rates up to 192 kHz. Supports optical (....
Check Stock

Aluratek HDMI 1080P to VGA Adapter with Audio - AHV100F

  • Aluratek's HDMI 1080p to VGA Adapter with Audio allows you to integrate video and audio output from a portable device, such as a laptop, smartphone or tablet to an analog VGA display (TV / monitors) or projectors..
  • Adapter supports high definition output, including 1080p for HDTV connections, and up to 1920 x 1200 (WUXGA) for computer VGA monitors..
  • Connect your HD enabled device and output to an analog VGA display or projector.
  • Audio support with analog and digital (optical) connections for 2.1 stereo audio: - 3.5mm jack, S/PDIF (optical)..
  • Supports Analog Video output up to UXGA and 1080p. Supports pixel clock rate from 25MHz to 165MHz.
Check Stock

Musou RCA Analog to Digital Optical Toslink Coaxial Audio Converter Adapter with Optical Cable Power Adapter

  • This is a Analog to Digital converter(Can NOT be used as a Digital to Analog Converter),Converts analog stereo audio signal from R/L input to Coaxial and Toslink outputs simultaneously..
  • Please note carefully the input and output of Musou Analog to Digital converter: INPUT is R/L and a 5v1A power supply, and its output Toslink and Coacial..
  • Digital audio cable length can run up to 15 feet without signal degradation. Supports output sampling rate at 48KHz.
  • Supports uncompressed 2-channel LPCM digital audio signal output.Supports output sampling rate at 48 KHz.【Solve audio problems by setting PCM audio format.】.
  • Provides electromagnetic-noise-free transmission.Note! only outputs 2 channels of sound.
Check Stock

Musou RCA Analog to Digital Optical Toslink Coaxial Audio Converter Adapter with Optical Cable Power Adapter

  • This is a Analog to Digital converter(Can NOT be used as a Digital to Analog Converter),Converts analog stereo audio signal from R/L input to Coaxial and Toslink outputs simultaneously..
  • Please note carefully the input and output of Musou Analog to Digital converter: INPUT is R/L and a 5v1A power supply, and its output Toslink and Coacial..
  • Digital audio cable length can run up to 15 feet without signal degradation. Supports output sampling rate at 48KHz.
  • Supports uncompressed 2-channel LPCM digital audio signal output.Supports output sampling rate at 48 KHz.【Solve audio problems by setting PCM audio format.】.
  • Provides electromagnetic-noise-free transmission.Note! only outputs 2 channels of sound.
Check Stock

Docooler 5.1 Audio Gear Digital Sound Decoder Audio Converter 3.5mm Audio Output Support for Dolby Digital AC-3 DTS US Plug

  • Supports for Dolby Digital AC-3 Dolby Pro Logic, DTS, PCM and other digital audio format source decoding, a variety of sound field and the replay results of two listening modes, 5.1 analog audio output..
  • Convert DTS/AC3 source digital audio to analog 5.1 audio or stereo audio output..
  • Convert the analog stereo (L/R) signals after digital processing chip into analog 5.1CH output..
  • Supports multi-channel audio input, including for 2x Spdif input, 1x Coaxial input, 1x Stereo input and 1x USB..
  • Allows to automatically work with different amplifier and speakers, to deliver different sound effects, easy to connect many entertainment devices with optical and coaxial digital signal and analog output signals..
Check Stock

Blackmagic Design Mini Converter - Analog to SDI

  • Analog to SDI Conversion: Use this device to convert analog video sources to SDI video output.
  • Embedded Audio: This unit can embed SDI audio from balanced AES/EBU or analog audio inputs.
  • og to SDI Conversion: Use this device to convert og video sources to SDI video output.
  • Embedded Audio: This unit can embed SDI audio from balanced AES/EBU or og audio inputs.
  • It will accept an HD/SD component, NTSC, PAL, or S-video signal and convert it to an SDI output.
Check Stock

ACEIRMC 8pcs HX711 Weighing Sensor Dual-Channel 24 Bit Precision A/D Module Pressure Sensor for Arduino Raspberry Pi Microcontroller

  • Analog Current Meter Module. Transformer can only sense AC.
  • This electricity sensor is based on TA12-100 current transformer, which can transform AC signals of large current into small amplitude signals..
  • 3-wire electronic block interface, input 5V - GND. S pin is the output analog voltage value..
  • You can use jumpers to select the parallel output of the output to adjust the range of analog values that are output..
  • On-board 3P and 4P connecting interface for current signal output can be easily connected with your MCU development board.
Check Stock

Vibration Switch Sensor Module, Piezoelectric Vibration Tapping Sensor Module Vibration Switch Module 5.0V DC AD/DO

  • An analog vibration sensor based on a piezoelectric ceramic sheet is an inverse transformation process that uses piezoelectric ceramics to generate vibration. When the piezoelectric ceramic piece vibrates, an electrical signal is generated..
  • Special sensor expansion boards are used in combination, and analog ports can be weakly perceived. Vibrating electrical signals enable interactive work related to vibration, such as electronic drum interactions..
  • ADO output: The analog voltage ceramic vibration sensor is connected to the controller analog terminal A0 according to the program. When the vibration degree is different, observing the output value of the serial port can realize the vibration-related in.
  • According to the greater the vibration intension, the higher the output voltage, the sensitivity of the vibration amplitude can be adjusted by the potentiometer..
  • This product has high sensitivity and can be adjusted to respond with a mouth blow or an output with a hand tap (Low turn sensitivity is low, right turn sensitivity is high)..
Check Stock

SOUTHSKY Audio Converter, Stereo Analog to Digital Converter Adapter, 3.5mm Aux Jack R/L 2 RCA Cinch to SPDIF,Toslink, Optical,Coaxial Converter

  • 【Stereo analog to digital audio converter】 Convert analog stereo signals from 3.5mm aux jack or R / L 2 cinch input connections to digital SPDIF, Toslink, optical, coaxial output connections. Warning, this adapter only supports analog to digital, not digital to analog, not bidirectional.
  • 【Connection interfaces with LED Indicator】 Metal housing, input: 1x3.5mm aux jack, 2xRCA R / L, left and right stereo analog channel.
  • Output: 1xSPDIF (Toslink, optical), 1xCoaxial.
  • 【High sampling rate of L / PCM】 Support sampling rate 32,44,1,48 and 96 kHz, R / L channel of S / PDIF is 24 bit, electromagnetic noise-free transmission. Note: Supports output of uncompressed 2-channel digital audio signals only. Not compatible with Dolby 5.1 or 7.1 or DTS.
  • 【Wide range of applications】 Supports switching the audio interface from HDTV, PC, laptop, computer, DVD player to your audio devices such as AV receivers, amplifiers, active speakers, soundbar..
  • 【Scope of delivery】 1x analog-to-digital audio converter, 1x USB power cable, 1x fiber optic cable, 1x 3.5 mm to 2 cinch cables ， 1x user manual.
Check Stock

DAOKI 5PACK piezoelectric Ceramic Vibration Sensor piezo 3.3V/5V Module Analog Controller Electronic Components Supplies Sensor for Arduino with Dupont Cable

  • When the piezoelectric ceramic shocking will generate an electrical signal, controller analog port can be perceived slight vibration signals, also can be realized with vibration interactions related works, such as electronic drums..
  • Working Voltage: 3.3V or 5V. Working Current: 1mA..
  • Please connect analog voltage ceramic vibration sensor to the UNO controller's analog port A0 in accordance with the procedure, then observe the output value of serial port when the vibration degree is different, it can realize interactive works related to the vibration..
  • This Ceramic Piezo Vibration Piece Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change which is proportional with the strength of vibration. So you can know the extent of vibration. Different from digital vibration sensor that only accounts times, this analog one can tell extent of vibration..
Check Stock